timingbelts.co.inFree timing belt tools
Timing belt tools › Timing belt length calculator

Timing belt length calculator

Enter two pulleys and the shaft spacing to get the belt. Or start from a belt to get the shaft spacing.

Shaft centre to shaft centre.

Belt for this drive

Already have the belt? Find the centre distance

Centre distance

How the calculation works

Each pulley’s pitch diameter comes from its tooth count z and the belt pitch p:

d = z × p ÷ π

For a large pulley D and a small pulley d at centre distance C, the exact belt pitch length is:

L = 2C·cos φ + π(D + d)/2 + φ(D − d),   where sin φ = (D − d) / 2C

A timing belt must have a whole number of teeth, so the calculator offers the belts either side of your exact length and works the centre distance back for each. Allow adjustment on one shaft for fitting and tensioning the belt.

Teeth in mesh

The small pulley carries the load through the teeth that are wrapped by the belt. With fewer than about 6 teeth in mesh the belt can jump teeth under load. If the calculator warns you, use a bigger small pulley or a longer centre distance.