Timing belt tools › Timing belt identifier
Timing belt identifier
Measure the teeth on a worn or unmarked belt and see which standard profile it matches.
Matching profiles
How to measure for the identifier
- Lay the belt flat, teeth up, with a steel rule along it.
- Put the zero on the leading edge of one tooth. Count 10 teeth along and read the rule at the leading edge of that tooth. That is the distance over 10 pitches.
- Look at a tooth side-on: straight sides with a flat top are trapezoidal; a curved tooth is rounded.
- If you can, count the teeth on the belt and measure its width. The tool then gives the full order code.
Profiles that look alike
- XL and T5, L and T10. Inch and metric pitches are close (5.08 against 5.00 mm; 9.525 against 10 mm). Over 10 pitches the difference is 0.8 mm and 4.75 mm, which a steel rule shows.
- T and AT. Same pitch, similar shape. AT belts are thicker and stiffer, with steeper tooth sides (50° against 40°) and a pulley to match. An AT belt will not run properly on a T pulley.
- HTD, GT and S-profile. All rounded, at the same 3, 5, 8 and 14 mm pitches. HTD teeth are deep and fully round; GT teeth are shallower; S-profile teeth have a flattened top. Each runs best on its own pulley.
Still unsure? Photograph the tooth side of the belt with a ruler alongside and send it with your enquiry.
Tooth heights are nominal and vary slightly between makers. Check a replacement against the pulley before fitting.