Free timing belt tools
Identify a worn belt, read a belt code, work out belt length and centre distance, and check pulley speeds. Standard drive geometry, worked out in your browser. No sign-up.
Identify a belt
Measure the teeth on a worn or unmarked belt and find its profile: HTD, T, AT, XL, L, H and more.
Decode a belt code
Turn codes like 800-8M-30, T10-1010-25 or 225L100 into length, pitch, teeth and width.
Belt length & centre distance
Two pulleys and a centre distance give the belt you need, or a belt gives the centre distance.
Pulley & speed
Pitch diameters, drive ratio, output rpm and belt speed from tooth counts.
Profile reference
Pitch and tooth height for 27 common profiles, inch and metric, in one table.
Which tool do I need?
- The belt has a code on it — use the code decoder.
- The code has worn off — measure the teeth and use the belt identifier.
- You’re designing or changing a drive — the belt length calculator gives the belt for your shaft spacing; the pulley & speed calculator gives the ratio.
How to measure a timing belt
- Pitch. Lay the belt flat, teeth up. Measure from the start of one tooth to the start of the tooth 10 pitches along, then divide by 10. Measuring over one tooth isn’t accurate enough: XL (5.08 mm) and T5 (5.00 mm) differ by only 0.08 mm a tooth.
- Tooth shape. Straight-sided, flat-topped teeth are trapezoidal (XL, L, H, T, AT). Rounded teeth are curvilinear (HTD, GT, S-profile).
- Teeth. Count every tooth on the belt. Mark the first with chalk. Length = teeth × pitch.
- Width. Measure across the belt.
A tape round the outside of the belt reads longer than its catalogue length, which is measured on the pitch line, inside the belt. Counting teeth avoids the problem.
Replacing a belt or pulley? ConveyPro Systems supplies timing belts and pulleys for industrial drives. Send the code or your measurements and we’ll come back with a price.